Model | DC-10 |
Stereo Mode (both channel driven) | Continuous Average Output Per Channel |
Maximimum output Power | Ch1 | Ch2 |
8 ohm/Stereo | 330W | 330W |
4 ohm/Stereo | 500W | 500W |
Continuous Sine Wave @ THD+N=0.1%,f= 1KHz | |
8 ohm/Stereo | 300W | 300W |
4 ohm/Stereo | 450W | 450W |
Bridge Mono Mode(both channel driven)
| Ch1 | Ch2 |
8 ohm/Stereo | 1000W |
Power Bandwidth (Ref. 1kHz, THD+N=0.1%,+0/-1dB) | 20Hz~20kHz |
THD+N (Ref. 1kHz,f=20Hz~20kHz) | ¡Â0.05% |
Frequency Response (Ref. 1kHz, 1watt output, +0/-1dB) | 20Hz~20kHz |
Crosstalk (RL=8¥Ø, Half power, Att.Max 600¥Ø shunt) | ¡Ã63dB, 1kHz |
Signal To Noise Ratio (Filter : A-Weighting, RMS) | ¡Ã100 dB |
Damping factor (RL=8¥Ø , f=KHz) | ¡Ã200 |
Input Sensitivity |
8 ohm/Stereo | Up to +2.1 dBu from 4 ¥Ø/Stereo Input |
4 ohm/Stereo | +0 OR +4.0 OR +7.0 dBu By Select Switch |
Voltage Gain (ATT.max) | 35.22dB |
Output Circuitry | Class-D |
Input Impedance | 6k¥Ø(Unbalance), 12k¥Ø(Balance) |
Controls |
Front panel | AC Switch, CH1 and Ch2 gain control knobs |
Rear panel | Low cut 30Hz Filter Output clip limiter, Sensitivity, ST/Mono Bridge, Parallel |
Connectors |
Input | Female XLR jack |
Output | XLR Male jack (Input Through), Speakon jack |
Indicators | Power (Green),Stan By (Green), Protect (Red), Clip (Red), Mono Bridge (Yellow),Parallel(Green),3 step Bar Graph In/Out Level |
Protection Circuits | 1)Short Circuits 2)Current Limit 3)DC detection 4)Thermal 5)Main Voltage Detect 6)Power supply shutdown 7)HF protection |
Fan Circuit | Fans Variable Low speed(50¡É), High speed(60¡É) |
Power Consumption (1/3 power) | 375Watts |
DIMENSION | 480 X 88 X 380 (mm) |
Shipipng Weight & Volume | 10.00kg / 0.0662cbm |