| PH-5.5 Power Amplifier |
| 8ΩStereo Power(RMS) |
550W |
| 4ΩStereo Power(RMS) |
750W |
| 2ΩStereo Power(RMS) |
900W |
| 8ΩBridged Power(RMS) |
1500W |
| Max RMS Output Voltage (each channel) |
82V |
| Max Peak Output Voltage |
116V |
| Frequency Response (+o/-0.3dB, 1W/8) |
20Hz-20kHz,-3dB@135kHz |
| Power Bandwidth (rated power at 4)1%THD+N) |
20Hz-20kHz, -.84dB/+0dB |
| TourClass Protection |
ACL,IGM, AutoRamp, short circuit, DC voltage, turn-on/off transient, current inrush, sub/ultrasonic input |
| THD+N (rated power. 4Ω/1kHz) |
<0.01% |
| SMPTE IMD (rated power. 8Ω. 60 Hz & 7kHz) |
<0.01% |
| Damping Factor (10-400Hz at 8Ω) |
400:1 |
| Input CMRR (1kHz) |
>-60dB |
| Standard Voltage Gain (rated power @ 8) |
0.775V |
| Standard Input Sensitivity (rated power at 8) |
X86.5 |
| Input Impedance (balanced/unbalanced) |
>20KΩ/>10KΩ |
| Hum and Noise ("A" weighted, full power at 4) |
-105dB |
| Crosstalk ("A" weighted, full power at 4) |
>-60dB |
| Class |
H |
| Input Connectors (per channel) |
Female XLR (pin 2+, configurable for pin 3+). TRS (tip+) |
| Output Connectors (per channel) |
5-way binding posts or Speakon connectors (market dependent) |
| Filter Storage |
80，000μF |
| Power Supply (factory configured) |
220V/230V,50-60Hz |
| Thermal Emissions (1/8 Power, 4) |
3250 BTU/hr |
| Thermal Emissions (1/3 Power. 4) |
4341 BTU/hr |
| Cooling |
TWO rear panel variable speed DC fans, filters detatchable without tools |
| Controls |
Front panel: 2 attenuators, power switch; Rear panel: signal ground lift & mode switches. |
| LED Indicators (per channel) |
Clip/Limit, Signal, Protect, Active |
| Construction |
Steel chassis, 16 gauge . Double thickness in rack ear areas. |
| Dimensions (Height x Width x Depth to rear rack ears) |
3.5" x19" x19.1"
88 x483x 486mm |
| Gross Weight |
521bs.(23.60kg) |
| Net Weight |
471bs.(21.331kg) |
| |
