INPUT
Connectors:
1/4" TRS, female XLR (pin 2 hot), and barrier terminal strip
Type:
Electronically balanced/unbalanced, RF filtered
Impedance:
Balanced 40k ohm, unbalanced 20k ohm
Max Input Level:
>+21dBu balanced or unbalanced
CMRR:
>40dB, typically >55dB at 1kHz
OUTPUTS
1/4" TRS, male XLR (pin 2 hot), and barrier terminal strip
Impedance-balanaced/unbalanced, RF filtered
Balanced 200 ohm, unbalanced 100 ohm
Max Output Level:
SYSTEM PERFORMANCE
Bandwidth:
20Hz to 20kHz, +/-0.5dB
Frequency Response:
<10Hz to >50kHz, +0.5/-3dB
Noise Reduction In:
(+/-6 and +/-12dB range):
Signal-to-Noise:
>102dB, unweighted, ref: +4dBu, 22kHz measurement bandwidth
Dynamic Range:
>120dB, unweighted
Noise Reduction Out:
(+/-6dB range):
>94dB, unweighted, ref: +4dBu, 22kHz measurment bandwidth
>112dB, unweighted
(+/-12dB range):
>90dB, unweighted, ref: +4dBu, 22kHz measurement bandwidth
>108dB, unweighted
THD + Noise:
<0.04%, 0.02% typical at +4dBu, 1kHz
Interchannel Crosstalk:
<-80dB, 20Hz to 20kHz
Noise Reduction:
Up to 20dB of dynamic broadband noise reduction
FUNCTION SWITCHES
Type III? NR:
Activates dbx? Type III? Noise Reduction
EQ Bypass:
Bypasses the Graphic Equalizer section in the signal path
Low Cut (recessed):
Activates the 40Hz 18dB/octave Bessel high-pass filter
Range (recessed):
Selects either +/- 6dB or +/-15dB slider boost/cut range
INDICATORS
Output Level Meter:
4-LED bar graph (Green, Green, Yellow, Red) at -10, 0, +10, and +18dBu
Gain Reduction Meter:
4-LED bar graph (all Red) at 0, 3, 6, and 10dB
Type III? NR Active:
Yellow LED
Red LED
Clip:
Low Cut Active:
+/-6dB range:
+/-12dB range:
POWER SUPPLY
Operating Voltage:
100VAC 50/60Hz, 120VAC 60Hz230VAC 50/60Hz
Power consumption:
23W
Main Connection:
IEC receptacle
PHYSICAL
Dimensions:
5.25" H X 19" W X 7.9" D (8.9cm x 48.3cm x 20.1cm)
Note: Specifications subject to change without notice.
