Rigid Kevlar Woofer For Accurate Playback The premium Kevlar woofer does not warp during playback, letting you hear your mix without distortion
정확한 재생을위한 엄밀한 케블라 우퍼
프리미엄 케블라 우퍼는 재생 중에 왜곡되지 않아 왜곡없이 믹스를들을 수 있습니다.
Balanced inputs provide the best sound quality transmission for your mixer or interface
Balanced XLR / TRS input for Low Noise Connection
Balanced inputs provide the best sound quality transmission for your mixer or interface
저잡음 연결을위한 밸런스드 XLR / TRS 입력
균형 잡힌 인풋은 믹서 또는 인터페이스에 최상의 음질 전송을 제공합니다.
LF 40W and HF 30W Bi-amplified Power The active monitors include a bi-amp power section and a crossover at 3.2kHz –outside of the critical vocal range
LF 40W 및 HF 30W 바이 앰프 파워
액티브 모니터에는 바이 앰프 전원 섹션과 임계 보컬 범위 밖의 3.2kHz에서의 크로스 오버가 포함됩니다.
Studio-Grade Amplification The crossover frequency of 3.2kHz was selected after extended listening tests to ensure that seamless response is achieved. Many monitors place their crossover frequency lower around 1-2k, allowing them to use less expensive components, but this causes phase distortion in the midrange where guitars, vocals, and other critical mix elements lie. The high-quality Kevlar driver allows TASCAM to set the crossover higher without distortion for truer reproduction of rock, hip hop, EDM, acoustic, or any other music genre.
The active, bi-amplified power section produces 70W per side – 30W to the highs and 40W for the low end. The monitor has balanced and unbalanced XLR and 1/4” inputs with a trim control. A large rear port extends the low end frequency response from 60Hz to 22kHz. The modern industrial design is sure to be the focus of any project studio.
